Tower Pro BMC-30A ESC
1. Make sure the Brushless motor is connected to the ESC
2. Set the Throttle stick to full ( 100% )
3. Plug the battery or turn the switch on
4. The brushless motor will produce a musical note and a steady tone.
this will be the setup menu, for each menu you will hear the tone 3 times before it moves to the next menu
menu 1 ∮— CELL Type and Number
menu 2 ∮— — BRAKE
menu 3 ∮— — — TIMING MODE
menu 4 ∮— — — — Protection voltage
5. To enter the menu you will need to move the throttle stick to the middle or 50% throttle.
6. This will let you enter the submenu
submenu 1. CELL Type and Number
• — NiMh/NiCd AUTO(0.8V/CELL*） delete this default setting before using
the speed controller.
• — — 2 LIPO （7.4V）
• — — — 3 LIPO（11.1V）
• — — — — 4 LIPO（14.8V）
• — — — — — 5 LIPO（18.5V）
submenu 2. BRAKE SET
•• — NO
•• — — SOFT
•• — — — MID
•• — — — — HARD
submenu 3. TIMING MODE SET
••• — 2 º for 2-4 grade motor
••• — — 7 º for 6-8 grade motor
••• — — — 15 º for 10-14 grade motor
••• — — — — 30 º for 10-14 grade motor
submenu 4. Protection voltage
•••• — 2.8V/CELL
•••• — — 2.9V/CELL
•••• — — — 3.0V/CELL
The tones will also be repeated 3 times on submenu.
5. To save the submenu settings, move the Throttle stick to full "100% " a long tone will be
produced meaning setting is saved.
6. To save ALL submenu settings, move the throttle stick down to 0 throttle. an acknowledgement tone will save all the settings.
7. Settings will be saved even after removing the battery.